The maintenance and repair of loader steel camel plays a great role in prolonging the service life of equipment, ensuring human-machine safety, improving work efficiency and increasing economic benefits. Therefore, the maintenance and repair procedures for loaders are specially formulated.
1、 loader steel camel Preparation before maintenance
（1） Check the hour meter,
(I) loader steel camel place the bucket flat on the ground;
（3） Shift operating lever is in "neutral";
（4） Pull up the loader steel camel parking brake operating lever;
（5） Place stops in front of and behind the loader steel camel tires.
2、 mini loader ht180 Maintenance cycle and contents
（1） mini loader ht180 Daily maintenance
Check whether there is oil, water and gas leakage and overheating of mechanical parts;
Check the mini loader ht180 hydraulic oil, brake fluid, engine oil, fuel level and water tank level;
Check the mini loader ht180 tire pressure, wheels and bolts of important parts;
Check mini loader ht180 instruments and lights;
Add lubricating grease to all calibration points;
Check the clearance between the axle seat at the junction of the subframe and the frame. If it exceeds 0.71001, replace the copper gasket.
（2） 50 hours or weekly maintenance
Repeat the mini loader hr180t contents of daily maintenance;
Check and fasten the connecting bolts of the front and rear transmission shafts;
Check the mini loader hr180t performance of emergency braking and parking braking;
mini loader hr180t Check the oil level of brake booster and transmission;
Check the throttle control and variable speed control system;
mini loader hr180t Drive axle maintenance;
Add lubricating grease (contact point of front and rear frame, swing frame of rear axle, etc.). www.haiqinmachinery.com